12V LED Beleuchtungsset & Treiber für 3D Drucker Druck Foto Gehäuse Octoprint Pi

12v LED Lighting Kit & Driver For 3D Printer Print Photo Enclosures Octoprint Pi

Description
12v LED Lighting Kit & Driver For 3D Printer Print Photo Enclosures Octoprint Pi

This is used to take a microcontrolled (arduino / raspberry pi) low voltage GPIO signal and control a higher voltage/current load.

Designed for use with octoprint and the LED Strip plugin on a 3D Print Enclosure - It will work fine with any microcontroller though.

There are 4 x RGBW Strips (Dedicated White LEDS) 18 LEDS Per Strip (Approx 30cm Each) To allow almost shadowless timelapse photos.

Fast switching Mosfets allow accurate PWM response without flickering.

All connections are labelled
Includes High Quality 12v Switching Power Supply

The strips include quality adhesive backing. The surface needs to be perfectly clean and dry before applying.
If used in a high temperature environment we recommend using clips or other mechanical fixings to secure the strips

Whilst designed for a printer enclosure we have had customers use for photograph lighting. with the dedicated white channel the strips are good for creating any shade of any colour.

PLEASE NOTE - A MICRO CONTROLLER IS REQUIRED

All items are tested, security marked & photographed before dispatch

From a non smoking and pet free household. Pictures are of the actual item(s) you will receive unless otherwise stated

•POSTAGE/COMBINED POSTAGE/POSTAGE ABROAD•
Please note we will post items anywhere fully insured/tracked. We will not post anything unrecorded or tracked for obvious reasons.

There will be extra charges for postage abroad which we are unaware of until actual posting.
We will normally charge a rough price for postage and then refund any extra after we take off the actual cost of packaging and postage.
As we currently receive a huge amount of mails, any regarding postage covered here may go unanswered.

We are happy to combine postage on items which again we cannot accurately judge until we have posted the…