3D LED Printer Direct Wire Pi Controlled PWM 12v / 24v Strip Lighting KIT
Description
3D LED Printer Direct Wire Pi Controlled PWM 12v / 24v Strip Lighting KIT
Here we have a great kit for smaller printers. Often printing late at night or using Octopi to control a printer in the closet. Then this is for you :)
This kit assumes you have some knowledge of working with your printer and a controller with controlled GPIO ports.
Designed for the Creality CR-20 Printer but will work on almost any printer. This kit requires a controller to switch and does not include a manual switch.
Includes
1x 12v LED Light Strip (33cm)
1x 12 / 24v Controllers Power Supply / Converter
3D Printed Mounts and end cap
Mounting Hardware & Fixings
Connect the bare wires to the power supply output and plug the power wire into the strip light. Connect the single control wire into a controller (3.3v, 5v & 12v) and off you go. This will switch the 12v output on when the control signal goes low
Works with Raspberry Pi, Octoprint, Arduino or basically any controller & software that allows control of the GPIO pins. This will allow PWM dimming control of the light strip :)
The 3D Printed PSU Case has mounting tabs and fixings designed to mount on the rails of most 3D printers.
We have ours fixed on the under or internal support rails along with our octopi.
28cm power supply wire, 80cm LED power wire and 70cm control wire.
All items are tested, security marked & photographed before dispatch
From a non smoking and pet free household. Pictures are of the actual item(s) you will receive unless otherwise stated
•POSTAGE/COMBINED POSTAGE/POSTAGE ABROAD•
Please note we will post items anywhere fully insured/tracked. We will not post anything unrecorded or tracked for obvious reasons.
There will be extra charges for postage abroad which we are unaware of until actual posting.
We will normally charge a rough price for postage and then refund any extra after we take off the actual cost of…
